Bring on the fun, with what is probably the best looking biplane out there. Fear not about long setup times of traditional biplanes, Pilot-RC's innovative and patented systems allow you to have the model completely put together in under 5 minutes, to then unleash the acrobatic and 3D monster that our Pitts.

Specifications:

Features:

• NEW! Pilot-RC new and patented quick release system for fast wing mounting at the field.
• NEW! Pilot-RC new quick release system for wing tension wires.
• Special Pilot-RC no screw canopy. Quick release with new security latch design.
• Strong but light, specially developed for precision acrobatic and extreme 3D flying
• Highly prefabricated, experienced builders can have air ready in under a day
• Pre-installed hinges (glued and pinned)
• Internally mounted cowling – so no external screws exposed
• Removable wings, wing stuts and stabs.
• Laser engraved motor mounting position

Included Hardware:

• Complete air frame with all basic accessories (such as carbon fibre main undercarriage, tail-gear assembly and wing-tubes as well as fibreglass control horns and wheel pants)
• Pre-installed hinges and pre-mounted canopy
• Fuel tank and fuel tubing pre-prepared, fuel dot and breather valve
• Wheels, axels and wheel pants
• Pre-prepared pushrods with ball links
• Matching 4.5in carbon spinner

Required Hardware (Not Supplied):

Engine/Motor: 100-120cc

Servos: 7-8 high torque plus throttle // Uses x1 per aileron (total x4), x1 per elevator and x1 or x2 on rudder

Also requires all the usual accessories such as transmitter, receiver, batteries, powerbox and possibly other small accessories.

Recommended Hardware (Not Supplied)

• Servos: MacGregor MG7232HV 31.5Kg.cm/0.09s High Voltage Servo or MacGregor MGB6928HV 28Kg/0.06s Brushless High Voltage Servo
• Servo arms: Pilot-RC 1.6in Aluminium arms (PIL302)
• Engine: DLE-111 (2-Stroke) | DLE-120 (2-Stroke) | EME-120 (2-Stroke) | Saito FG-100TS (4-Stroke)
• Wingbags: Pilot-RC 87in (100cc) Pitts Wingbag (PIL590)

Video:

Pilot-RC: Pitts S2B

This very simple videos shows just how quickly you can put together and then take apart our new Pilot-RC 87" Pitts at the flying field.

Will It Fit In My Car?

Build Information:

Cowl Size

A: 286mm | B: 308mm | C: 324mm | D: 320mm

Exhaust Tunnel Size

A: 348mm | B: 115mm | C: 387 | D: 131mm | E: 172mm

Extension Wire Lengths

• Throttle: 40cm
• Upper wing: No extension required
• Wing strut:(x2) 52cm
• Lower wing: (x2) For wing servo: 60cm | (x2) To wing strut: 87cm
• Elevator: (x2) 95cm
• Rudder: For Pull-Pull 10cm

Centre of Gravity

225mm - Measured back from leading edge of the top wing at the fuselage.