MacGregor MGB6928HV 28Kg/0.06s HV Brushless Digital Servo

Price: £89.95


Add to Basket:

IN STOCK

Features

  • High Performance, Standard Size, High Voltage Digital Servo
  • High-Precision 7075 Aluminium Gear
  • Long-life Potentiometer
  • Full CNC Aluminium Case, with Anodised Purple Centre Case
  • High Quality Brushless Motor
  • Dual Ball Bearing
  • Waterproof
  • 25T Spline
  • Suitable for 1/8,1/10 Nitro Car, upto 60CC Aeroplane, 600-800 Class Helicopter CCPM

Overview

The MGB6928HV is a waterproof ultra high speed and torque brushless digital servo, part of MacGregor's range of high voltage servos designed for General use in RC Aeroplanes, Cars & Helicopters.

Battery chemistries such as Li-Po, Li-Ion, and Li-Fe have become very popular within the RC community. They are the standard for powering electric motors and have also gained popularity as receiver battery packs. The issue is the output voltage of these batteries is higher then the previous standard 4 - and 5-cell NiCd and NiMH packs, 4.8V and 6V respectively. The higher voltage is not an issue with the receivers but can be for the servos. Many servos will not operate at these higher voltages for very long before burning out the motors or electronics.

To get around this issue modellers have had to use a regulator to drop the voltage to an acceptable operating range for their servos, usually around 5 to 6 volts. The addition of a regulator adds a component that, should it fail, can cause the loss of a model.

MacGregor's HV servos are designed with motors and electronics that operate off the direct voltage of a 2-cell Li-Po, Li-Ion, or Li-Fe receiver battery pack. This eliminates the need for a regulator and lowers the chance for a power failure that can cause a catastrophic failure of your model. Also note that the HV servo specs are shown at the higher voltage (8.4V 2S LiPo) but will still operate on a standard 5-cell 6V NiCd, Ni MH battery with a reduction in performance of approximately 10% in speed and torque.

Specifications

Dead band:2µs
Working frequency:1520µs / 330hz
Motor:Brushless Motor
Gearset:Full Metal
Spline:25T
Operating Voltage:5.0 ~ 8.4V
Operating Speed (6.0V):0.08sec/60°
Operating Speed (8.4V):0.06sec/60°
Stall Torque (6.0V):22.2kg.cm
Stall Torque (8.4V):28kg.cm
Dimensions:40 x 20 x 40.9mm
Weight:69g (2.43oz)
Connector Wire Length:JR 300mm
Bearing:2BB
MGB6928HV Servo Drawing

  • Model:
    [MACB6928HV]

This product was added to our catalog on Wednesday 07 February, 2018.